tomm1111
202 posts
msg #67808
- Ignore tomm1111
modified |
9/27/2008 12:42:50 AM
chetron...only if I can find entry's and exit's like I can assemble filters! LOL
Check this out. I removed some stuff from it. Does this work for basic sub?
Look for extremes on clo, d_5, and rsi(3). Also, look for spike on the bottom plots.
tomm
|
chetron
2,817 posts
msg #67817
- Ignore chetron |
9/27/2008 9:24:43 AM
no good, tomm. the restriction is you can't use a custom ma, that uses a custom variable, to create a custom variable, ie: x=cema(var1,3).
|
tomm1111
202 posts
msg #67824
- Ignore tomm1111
modified |
9/28/2008 12:04:28 AM
Some adjustments in the works... I will update filter as necessary.
|
TheRumpledOne
6,411 posts
msg #67827
- Ignore TheRumpledOne
modified |
9/28/2008 10:40:07 AM
no good, tomm. the restriction is you can't use a custom ma, that uses a custom variable, to create a custom variable, ie: x=cema(var1,3).
+++++++++
??
xrange and xavgrange are both custom variables ( I think ).
|
chetron
2,817 posts
msg #67829
- Ignore chetron
modified |
9/28/2008 11:25:05 AM
BUT TRO, HIGH AND LOW ARE SF VARIABLES. VAR1 IS A CUSTOM VARIABLE.
***************************
I JUST TRIED TO NAIL IT DOWN AND IT CONTINUES TO ELUDE ME.
WHAT I DO KNOW IS THAT IF YOU TAKE THE MATH OUT OF
set{var1,hat2 * 1.5}
set{x,cema(var1,3)}
set{s,exp(x)}
AND MAKE IT
set{var1,hat2}
set{x,var1}
set{s,x}
THE RESTRICTIONS ARE OFF.
ALSO MINUS THE "PLOT ON" COMMANDS
AND MINUS THE DRAW CLO LINE
|
tomm1111
202 posts
msg #67836
- Ignore tomm1111 |
9/28/2008 5:26:52 PM
FYI - I modified all the filters I posted in this thread. Results should be very similar.
I did seem to run into a limit somewhere as I cannot do what I first intended with the clo and clo lines (or even screening capabilities. for example "clo crossed below 0.85")
...works in progress.
tomm
|